2-20amp 120V circuits to control 24 Volt water valve solenoids.
"WAC 296-46B-900(3)(a)(v)(D): Service or feeder loads are not increased by more than 5% of the rated capacity of the electrical equipment supplying the modified load(s)." · Electrical
2-20amp 120V circuits to control 24 Volt water valve solenoids.
"WAC 296-46B-900(3)(a)(v)(D): Service or feeder loads are not increased by more than 5% of the rated capacity of the electrical equipment supplying the modified load(s)." · Electrical
No product keyword matched · Seattle electrical permits
Removing and replacing 2 200 amp Zinsco panels with new. Removal of knob and tube in dish pit floor joists for framing repair.
Disconnect and reconnecting of equipment in dish pit. Light fixture replacement in dish pit and main electrical room · Electrical
No product keyword matched · Seattle electrical permits
Criminals disconnected the SCL utility primary ground wires and the neutral on the 480 volt side of the SCL utility transformer (SCL repaired and replaced.) Interior Damage was to a large percentage of light fixtures and controls ensued from overvoltage. This permit is for the emergency repair/replacement of those fixtures and controls. [5-12-26 D Rankin - Spread sheet for replaced lights of like kind and same would work for plans] [5/18/26 BGO - Approved Plan Set with Comments] · Electrical
No product keyword matched · Seattle electrical permits