EXPLORE ELECTRIC LLC

Filing to remove violations 35384556Z and 35358820J associated with apartment 18

decommissioning existing electrical panel and installing a new electrical panel below it. All branch circuits will be extended less than six feet. In addition, one 20 amp 120 volt (2400 watt) dedicated circuit will be added to serve a window A/C unit located in the living room area.

Unit #4B. For a pre-manufactured Pergola built on the outside upstairs patio area. A sub-panel will be added to the inside upstairs portion of the condo and three (3) branch circuits will be added to accommodate electrical equipment and power for the individual pergola. A light outlet and a receptacle outlet will be relocated about six feet (6') outside, also a receptacle outlet will be relocated about three feet (3') inside for the anticipation of a new glass patio window.

Adding HVAC to permit for (4) outside HVAC units. A inspection was conducted for Q01372582I1EL for the exact same work. This permit is pulled to address the violation payment.

This is a minor work Permit. HPD Violations are being addressed in the first floor Unit. The work will be: Repairing existing light in kitchen, replacing switches in the dining room, installing a wireless doorbell system, changing out a breaker, and making sure wires are safe and not exposed at two receptacle outlets outside.

pulling a permit for un-permitted electrical work. The property work has been inspected and received a pass (Q01372582-I1-EL). The payment for the ""Work without a Permit was not paid."" This permit is being utilized to pay ""Work without a Permit"" fee. Four (4) condensers installed on outside of home, require new over-current protection compatible with ti load-centers. New properly sized wires will be reinstalled

Addressing violation 39184139R, work conducted without a permit. Removing basement lights.

This is to address the violation 39184140Y issued for exposed wiring not properly capped with wire-nuts inside junction boxes.

Pulling a permit for un-permitted electrical work. Four (4) condensers installed on outside of home, require new over-current protection compatible with the load-centers. New properly sized wires will be reinstalled.

Replacing meter socket enclosure. Old existing meter socket enclosure for unit 3R is not compatible with new ConEdison meter and requirements.

Condenser unit, mini-split system, installed without electrical permit. AC Mini Split Unit installed on front side of home.

Replacing Federal Pacific Electric Panel with new Electric Panel over 30 Amps

Changing an electrical box. Disconnecting a switch from the light in a room. The light will be controlled be a remote that comes with light. No new circuits will be added.